Home » Science Lab Technology » SOLID-PHASE EXTRACTION OF NICKEL (II) ION BY STUDYING THE EFFECTS OF SAMPLE VOLU...
SOLID-PHASE EXTRACTION OF NICKEL (II) ION BY STUDYING THE EFFECTS OF SAMPLE VOLUME ON COATED SILICA GEL AND PRODUCTION OF SCHIFF’S BASE (BHPDE)
Sold By: Joe Project Store | Item Type: Project Material | Report this? | Attributes: 65 pages | 1-5 chapters | Amount: ₦5,000 | Marked useful: 5,135 times
Delivery: Within 24 hoursSOLID-PHASE EXTRACTION OF NICKEL (II) ION BY STUDYING THE EFFECTS OF SAMPLE VOLUME ON COATED SILICA GEL AND PRODUCTION OF SCHIFF’S BASE (BHPDE)
ABSTRACT
Bis-(4-hydroxypent-2-ylidene)-diaminoethane(BHPDE) is a Schiff base resulting from the condensation of pentane-2-,4 dione and 1,2-diaminoethane.Solid-phase Extraction of Ni (II) ion by column method in the pH range 1- 12 have been studied in trichloromethane using bis-(4-hydroxypent-2-ylidene)-diaminoethane(BHPDE). Ni (II) ion extraction using 2% BHPDE in CHCl3 is sufficient or abundant in the pH of 4.0. The aqueous BHPDE shows a maximum absorption at 320nm. The Ni (II) ion complex has maximum absorption at 375nm. The acid dissociation constants of H2B (BHPDE) are obtained by titrating with 0.179 M NaOH and are found to be pka1D = 11.55 and pka2D = 11.5 corresponding to the formation of HB- and B2 respectively. Pka1D and pka2D share the same value since H2B (BHPDE) has two protons located in the same chemical environment. Electronic Spectrum of BHPDE confirms that BHPDE absorbs maximally in the ultraviolet region of the spectrum and not in the visible region since it is not displayed in the spectrum. The physical modification of the silica gel using BHPDE has also been studied.
TABLE OF CONTENTS
Title page i
Certification page ii
Dedication page iii
Acknowledgement iv
Abstract v
Table of contents vi
CHAPTER ONE
1.0 Introduction 1
1.1 Background of the study 1
1.2 Objectives of the study 3
1.3 Statements of the problem 4
1.4 Hypothesis 5
1.5 Significance of the study 6
1.6 Limitation of the study 6
CHAPTER TWO
2.0 Literature review 7
2.1 Steps in solid phase- extraction 7
2.2 column and batch extraction method 10
2.3 Sorbent in solid- phase extraction 11
2.3.1 Silica gel 12
2.3.2 C18 - bonded silica gel 15
2.3.3 Aminopropyl silica gel 15
2.4 Metal ions under study 16
2.4.1 Nickel (II) ion 16
2.5 Pre-concentration of metal ions 17
2.5.1 Optimal pH 17
2.5.2 Exchange capacity SPE 18
2.6 Adsorption Isotherm 18
2.6.1 The Langmuir isotherm 20
2.6.2 Freundlich isotherm 20
2.7 Immobilized ligands in the solid-phase
Extraction 21
2.7.1 Chelation 21
2.7.2 Schiff’s bases 23
2.7.3 Salen 24
CHAPTER THREE
3.0 Materials and Method 26
3.1 Materials 26
3.1.1 Instruments/Equipment 26
3.1.2 Chemical reagents 28
3.2 Method 32
3.2.1 Synthesis of the Schiff’s base (BHPDE) 32
3.2.2 Activation of silica gel 33
3.2.3 Preparation of stock solution of the ligand (BHPDE) 34
3.2.4 Preparation of the buffer solutions
(PH1- pH 12) 35
3.2.5 Preparation of immobilized Schiff’s base
(BHPDE) silica gel 35
3.2.6 Preparation of the extraction column 36
3.2.7 Effect of sample volumes on coated or
Modified silica gel 36
3.2.8 Preparation of the standard calibration
Curve of the Ni (II) complex 38
3.2.9 Determination of the acid dissociation
Constant of the BHPDE 39 3.2.10 Determination of wavelength of maximum absorbance (⋋max) of aqueous BHPDE 39
CHAPTER FOUR
4.0 Result and Discussion 41
4.1 Results 41
4.1.1 Activation of silica gel 41
4.1.2 Properties of BHPDE 41
4.1.3 Electronic spectrum of BHPDE 42
4.1.4 Acid dissociation constants of BHPDE 43
4.1.5 Effect of sample volumes on modified
Silica gel 44
4.2 Discussion 46
4.2.1 Activation of silica gel 46
4.2.2 Properties of BHPDE 46
4.2.3 Electronic spectrum of BHPDE in
aqueous Solution 47
4.2.4 Acid dissociation constants of BHPDE 48
CHAds PTER FIVE
5. 0 Conclusion and Recommendation 49
5.1Conclusion 49
5.1.1 Recommendation 50
References 52
CHAPTER ONE
1.0 INTRODUCTION
1.1 Background of the study
Solid phase extraction (SPE) is a sample preparation technique by which compounds that are dissolved or suspended in a liquid mixture are separated from other compounds in the mixture according to their physical and chemical properties. Solid phase extraction has two phases which are stationary phase and mobile phase; the stationary phase is the silica gel while the mobile phase is nitric acid (Hennion and marie-claire, 1999).
Solid phase extraction uses the affinity of solutes dissolved or suspended in a liquid (known as the mobile phase) for a solid through which the sample is passed (known as the stationary phase) to separate a mixture into desired and undesired components. The result is that either the desired analytes of interest or undesired impurities in the sample are retained on the stationary phase. The portion that passes through the stationary phase is collected or discarded, depending on whether it contains the desired analytes or undesired impurities. If the portion retained on the stationary phase includes the desired analytes, they can then be removed from stationary phase for collection in an additional step, in which the stationary phase is rinsed with an appropriate eluent. Schiff base named after Hugo Schiff is a compound with the general structure R2 C=NR1 (R1≠H) where R stands for a phenyl or alkyl group which makes the Schiff base a stable imine. This kind of ligands is able to coordinate metal ions through the imine nitrogen. Schiff base is normally applied to these compounds when they are being used as ligand to form coordinate complexes with metal ions. Its function is to increase the pre-concentration of the metal ions.
Solid phase extraction technique has several advantages over other pre-concentration methods in terms of reusability of the adsorbent, higher pre-concentration factor, lower consumption of reagents, ease of automation, its environmental friendliness, simplicity, economy. SPE technique is based on adsorption of the metal ion (nickel (II) ion) on silica gel coated with Bis (4-hydroxypent-2-ylidene)-diaminoethane (BHPDE) as a ligand (Taylor and Francis, 2000).
1.2 Objectives of the study
· The objective of this study is to activate and modify the silica gel and to develop the calibration curve of Schiff base.
· To be able to measure the quantity of a compound accurately, and to determine λ max of (BHPDE) ligand.
· To synthesize Schiff' base which can be used as ligand in the solid support surface to get a new sorbent with high sorption or adsorption efficiency.
· To test the power of the prepared SG-extractor in pre-concentration of Ni (II) ions from aqueous solution.
· To optimize the conditions for extraction.
1.3 Statement of the problem
Different techniques are used for the separation and pre concentration of metal ions in the solution. Sample preparation techniques among which are liquid-liquid extraction, precipitation, Volatilization, ion-exchange mechanisms, etc are characterized by higher consumption of reagents, lower pre-concentration factor, inability to reuse adsorbent where obtainable, capital intensive and not environmentally friendly.
However, solid-phase extraction technique is the most popular sample preparation method which can be favored and advantageous in the area of its simplicity, ease to automation, lower consumption of reagents, economy, environmentally friendly and above all, high pre-concentration factor.
1.4 Hypothesis
Ho (Null hypothesis): Solid phase extraction of trace metals with the Schiff base Bis-(4-hydroxy pent-2-ylidene)-diaminoethane by column method.
Ha (alternate hypothesis): Solid phase extraction of trace metals without the Schiff base Bis-(4-hydroxypent-2-ylidene)-diaminoethane by column method.
1.5 Significance of the study
In this study, Schiff base was synthesized which was used as a ligand in the solid phase support surface to get a new sorbent with high sorption efficiency.
Secondly, we were able to determine the concentration of some selected trace metals commonly found in our environment. This study may be useful to the young researchers who intend to investigate metal ions in our environment.
1.6 Limitation of the study
This research work is limited to the use of solid particles silica gel to extract solute from liquid samples. It does not involve the study of gaseous samples that can be passing through the packed columns but rather only deals on liquid sample. This study uses Bis-(4-hydroxy pent-2-ylidene)diamino ethane as its Schiff base. The research also focuses only on one trace metal such as nickel (II) ion.
This material content is developed to serve as a GUIDE for students to conduct academic research
Delivery: Within 24 hours
Advertise Here
Not what you were looking for? Perform a search
What's your project topic?
Comment on Facebook:
Related Project Materials
- 1.
THE PREVALENCE OF MALARIA AMONG PREGNANT WOMEN ON ADDMISSION IN IMO STATE SPECIALIST HOSPITAL OWERRI
THE PREVALENCE OF MALARIA AMONG PREGNANT WOMEN ON ADMISSION IN IMO STATE SPECIALIST HOSPITAL OWERRI ABSTRACT A study was made to determine the prev...More »
Item Type: Project Material | 40 pages | 14,587 engagements |
- 2.
ANALYSIS OF SOME MINERAL CONTENTS OF COCONUT WATER
CHAPTER ONE Introduction Background of the Study The coconut (Cocos nucifera L.) is a tropical plant which belong to the order Arecales and f...More »
Item Type: Project Material | 50 pages | 11,439 engagements |
- 3.
DETERMINATION OF SOME TRACE ELEMENTS IN RAW PERIWINKLE Tympanotonus fuscatus
CHAPTER ONE Introduction Trace elements are natural components of the earth’s crust; they are stable and persistent contaminants of coastal...More »
Item Type: Project Material | 50 pages | 7,653 engagements |
- 4.
ESTIMATION OF THE LEVEL OF SOME HEAVY METALS IN SOIL COLLECTED FROM AN AGRICULTURAL FARM
Chapter One 1.0 Introduction Heavy metal refers to any metallic chemical element that has a relatively high density and is toxic or poisonou...More »
Item Type: Project Material | 50 pages | 9,381 engagements |
- 5.
MICROBIOLOGICAL ANALYSIS OF DRY CASSAVA PEEL USED IN THE PREPARATION OF PIG FEEDS
CHAPTER ONE 1.0 Introduction Manihot esculenta with common names ‘‘cassava’’, is a woody shrub of the spurge family, Euphorbi...More »
Item Type: Project Material | 50 pages | 8,794 engagements |
- 6.
BACTERIOLOGICAL EXAMINATION OF FRIED SNAIL
INTRODUCTION Snails belong to class Gastropoda, a classification that includes land, freshwater and sea snails and slugs. Snail’s ancestors are ...More »
Item Type: Project Material | 34 pages | 7,146 engagements |